Lightweight Design Drone Detection Device For Tactical And Mobile Operations
Drone Detector With Compact And Lightweight Design For Tactical And Mobile Operations
Introduction
Drone Detector With Compact And Lightweight Design For Tactical And Mobile Operations is a high-end, advanced device for stationary monitoring of drones, designed for continuous airspace management and safety missions. Equipped with advanced radar and optical sensors, the system tracks various UAV targets in real-time and accurately displays their flight trajectories. By integrating intelligent analysis software, users can visualize the location, speed and route of drones on the monitoring interface, thus enabling rapid response and greatly improving airspace safety.
Parameters
|
Function |
Description |
||
|
UAV detection |
Detection spectrum bandwidth |
70 MHZ - 6GHZ |
detection focus on the 433Mhz/ 900Mhz/2.4Ghz/5.2Ghz/5.8Ghz |
|
The lowest detection height |
≦0 meters |
can be customize with 1Ghz -1.4Ghz & 5.1Ghz - 5.9Ghz FPV Bands |
|
|
White and Blacklist |
Number of identifiable models |
≧ 400 |
including DJI series drones,and it has the autonomous learning ability |
|
the accurate identification of target |
Available |
for different targets of the same position, same frequency band, same manufacturer, same type of UAV respectively. |
|
|
in-depth analysis of UAV signal |
|||
|
the identification of unique ID |
|||
|
the black and whitelist to distinguish |
|||
|
Defensive Interference |
Interferable frequency bands |
900MHz, 433Mhz, 1.5ghz, 2.4ghz, 5.8ghz, 5.2Ghz and on |
|
|
Remote OAM |
Unattended Mode |
Automatic detection and strike |
|
|
A variety of OAM features |
Firmware updating |
used with the remote server |
|
|
Reset, status inquiry |
|||
|
Self-testing |
|||
|
Parameter configuration |
|||
|
Networking |
Multi-device networking |
observe the online/abnormal status of each device |
|
|
Remote control through mobile terminals |
viewing the operating interface of the device system |
||
|
receiving alarm information |
|||
|
viewing the black and whitelist |
|||
|
turning on defense function |
|||
Power Supply
The System is designed to operate at 200~240 V, 50/60Hz, 2.5A Max and 50W in detection mode, 200~240 V, 50/60Hz, 2.5A Max and 500W in Jammer mode, The SystemPower Cable is used to connect the The System stationary unit to a power supply. In addition, it can also use DC power if necessary.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.