Roller type abrasion testing machine

The roller type wear testing machine mainly consists of a power system, a rotating roller, a sample gripper, an automatic shutdown system, a rack and pinion gear device for sample rotation, a base, and a dust collector. The main principle is: under a certain load, on a certain level of gauze, a cylindrical sample is cross cut and ground on the surface of the gauze for a certain stroke. The mass wear of the sample is measured, and the volume wear is calculated from the density of the sample. In order to make the experiment comparable, standard rubber must be used, and the test results should be expressed as the relative volume wear based on the verified gauze or as the wear base relative to a certain standard rubber.
2, Main technical specifications
Drum diameter: 150 ± 0.2mm
Roller length: 460mm
Drum speed: 40 ± 1r/min
Sample used: diameter: 16 ± 0.2mm, thickness not less than 6mm
Transverse movement speed of sample holder: 4.2 ± 0.06mm/r
Grinding stroke length: 20m or 40m
Sample grinding speed: 0.9r/min or no rotation
Self load: 2.5N (generated by sample clamp and cantilever)
The sample load can be adjusted to weight: 5N, 7.5N, 10N, 12.5N, 15N, 17.5N, 20N (using three attached weights)
Output power: AC220V 50Hz
Motor speed: 3000r/min