APPLICATION:Industrial design, electronic product housing, car modification, exhibition display, art decoration and other industries and scenarios

DIRECTIONS FOR USE:

1. Surface Preparation
   Ensure the substrate is clean, dry, and free of oil, dust, and rust.
   Metal surfaces may require sanding or primer to improve adhesion.
2. Shake the spray can thoroughly before use for about 1-2 minutes to evenly mix the paint.

3. Spraying Procedure

   Keep the spray gun/can approximately 20-30 cm from the surface being sprayed.
   Apply a uniform, parallel spray motion, applying multiple, thin coats to avoid over-spraying.

4. Drying and Overcoating
   The fast-drying design allows for a quick dry time, typically drying to the touch in 10-15 minutes.
   If a higher film build is desired, reapply after the paint has dried.

WARNINGS:

• Apply in a well-ventilated environment and avoid inhaling spray.

• Avoid open flames and high temperatures during application.
• After spraying, store any remaining paint properly and avoid direct sunlight.
• For special substrates or surfaces exposed to long-term outdoor conditions, it is recommended to test a small area to confirm adhesion and color performance.