PTC Over The Side Immersion Heater Single Or Three Phase Power Heater 1kW - 6kW
SmartOne heaters' elements are PTC positive temperature coefficient semiconductors - making the heaters self-limiting. That is, they reach a set maximum sheath temperature (which is below the ignition point of most combustible materials), meaning they are especially safe for process applications.
- PTC heater element lasts longer than conventional heaters
- Will not burn out if run in air
- Will not burn out due to scale or sludge buildup
Heater self limits its maximum operating temperature to 250°C. This is lower than the ignition point of most plastics.
- Will not melt tanks when a 1/2" (12mm) minimum distance is maintained
- Overtemperature protection devices are not required
- Safety is built-in, not added on
- Metal-grounded construction (earth ground)
- Non-floating construction
Sizes: 1,000 watts (1kW) to 6,000 watts (6kW)
Voltages: Three voltage ranges available: 110-120 volt, 200-240 volt, and 380-480 volt. Heater is available in single or three phase power.
Vapor-resistant, flame retardant polypropylene terminal enclosures each with 3-foot (.9m) flexible PVC liquid tight conduits.
- Watt densities of 4 watts/cm² ensure long service life
- Auto-stabilizing solid state element prevents hot spots and ensures uniform heating
- Heater derates itself in highly viscous and high temperature solutions
Consult factory for sizing assistance.
For use in most aqueous alkaline, electroplating and rinse solutions. Check our Solution Guide or with your chemical supplier for recommended sheath material. Available in:
- 304 stainless steel
- 316 stainless steel
- Titanium
Consult factory for the following:
- Longer wire and conduit lengths
- Extended cold zones
- Temperature and level controls sized to match the heater
We recommend temperature controls and level controls for use with this immersion heater.
Designed with Ultra-High-Purity processes in mind, Surplus delivers clean-room assembled, reliable heating and power solutions to fit specific needs.
Anodizing is an electrochemical process of converting a metal surface into an oxide layer. Mainly aluminum is used for anodizing, although other nonferrous metals, such as titanium and magnesium, can also be anodized. The metal part is connected as the anode and immersed into an acid electrolyte bath, where an electric current is applied to grow the oxide layer from the piece. The resulting surface finish will provide functional properties as corrosion-resistance and durability, as well as decorative properties. Surplus heaters provide beautiful, precise finishes. Surplus power supplies deliver high current, high accuracy, and high energy efficiency to meet a modern anodizing process's requirements.
Derated, low watt density, L-shaped, bottom, metal over the side Immersion Heater. Single or Three phase. Three phase. 500-6000 watts, 120-480 volts.
L-shaped, bottom style metal over the side heater. Three phase. Single or three phase. 3000-36000 watts, 200-600 volts.
Over the side, 6 element, tubular heater. Three phase. 6000-21000 watts, 208-600 volts.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.