GLM-2016HL Gantry Machining Center with FANUC System

Standard Configuration:

Operating handwheel, double screw + chain-type chip removal, spindle oil cooler, water gun, air gun, spindle air curtain, spindle ring spray, centralized lubrication, air source treatment, oil-water separation, heat exchanger, knife library balance

Optional Configuration:

Mitsubishi/New Generation System, hollow screw, electrical cabinet air conditioning, 4-axis, 5-axis, column heightening, full gear spindle, manual/automatic side milling head, side milling head library, internal tool cooling, tooling, fixtures

※ The appearance and configuration of the product will be improved with technological development (but not lower than current technical requirements), and no separate notification will be given. The specific technical agreement at the time of purchase shall prevail;

※ There are many types of gantry models. The above are some models of our company. For unlisted specifications, please visit the official website or consult the corresponding customer manager;

Note ①: The 3-axis power and torque are based on the FANUC system. For detailed data of Mitsubishi and New Generation systems, please consult the corresponding customer manager;

Note ②: Optional BT50-190 spindle;

Note ③: If the model is out of stock, HIWIN, Rexroth, THK of the same specification will be used as substitutes, and no separate notification will be given;

Note ④: The X-axis and Y-axis can be equipped with 55mm linear rail width;

Note ⑤: The Z-axis can be equipped with a rack;

Note ⑥: The tool magazine capacity can be equipped with 30T;