JINJIA DC02IB DC power jack connector designed for stable power input in various electronic products

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

Product Overview

This specification applies to DC POWER JACK connectors used in electronic products. These connectors are designed for reliable power input in various electronic devices.

Product Attributes

Brand: Shenzhen JinJiaRun Electronics Technology Co.,Ltd
Origin: Shenzhen
Model Type: DC POWER JACK

Technical Specifications

Item	Property	Test Condition	Performance
Rated /	Practical temperature range	-20to +70	85% RH.MAX. Humidity
Rated /	Rated voltage and current(MAX.)		30V DC , 2A
Electrical efficiency /	Withstand Voltage	Withstand AC 500V (50/60Hz RMS) between two non-contact terminals for 1 minute	No dielectric breakdown shall occur.
	Insulation Resistance	Apply 500V DC between any contactless terminal and the other terminal, with an insulation gauge and last for 1 minute 5 seconds.	100 M Min.
	Contact Resistance	Take a pair of matched terminals and measure the tail end of each terminal (voltage maximum 20mV, current maximum 100mA)	30 m MAX.
Mechanical Performance	Insertion and Extraction Force	Plug and unplug with a matching plug at a frequency of 20-30 times per minute.	Insertion and extraction force is 0.33kgf
Mechanical Performance	Terminal Strength	Every terminal should be capable of withstand a force of 0.5 kgf for 10 seconds.	No looseness, damage, etc., but the terminal deformation is acceptable.
Durability /	Life test	Under the condition of no load, plug and unplug with a matching plug for 5000 times in total, at a frequency of 20-30 times per minute.	Appearance no obvious change, destruction. Contact resistance: less than 30 m. Insertion and extraction force values: 0.3 to 3 kgf.
Solderability /	Resistance to soldering heat	The jack terminal should be dipped in solder: Temperature of solder: 2603. Dip time: 51 seconds.	After the test, the plastic base should not be deformed and the terminals should not fall off the plastic base.
Solderability /	Solderability	Temperature of solder: 2453C. Time of dip: 30.5 seconds.	Coating of solder area should be more than 95%
Environment test /	Cold test	Place the housing for 96 hours at a low temperature of -25 3 C. Then ,place it under standard atmospheric conditions for 1 hour and test.	No obvious change in appearance. Contact resistance: 100m max. Insulation resistance: 100 M min. Withstand voltage: AC 500V.
	Heat test	The housing should be stored at a temperature of 852for 96 hours. Then it should be subjected to standard atmospheric conditions for 1 hour and test.
	Humidity test	The housing should be stored at a temperature of 403with relative humidity of 90% ~ 95% for 96 h. Then it should be subjected to standard atmospheric conditions for 1 hour and test.	No obvious change in appearance. Contact resistance: 100m max. Insulation resistance: 100 M min. Withstand voltage: AC 500V.
	Salt spray test	Temperature: 35 2 Solution: 5 1% Spray time: 24hours Wash and dry it at room temperature after the experiment.	No obvious rust in the appearance.