A: Hardwire means the mirror connects directly to in-wall electrical wiring (typically via a junction box), with no exposed power cord or plug. Key differences:

• Appearance: Hardwired mirrors sit flush against the wall — much cleaner

• Safety: No loose plug, better for humid bathrooms

• Control: Often linked to a wall switch or with an integrated touch switch

• Installation: Requires pre-wired power and a licensed electrician — not plug-and-play

A: For small to medium bathrooms (4–8 sq m / 43–86 sq ft), yes, it can be the sole light source. However, note that LED mirrors direct light forward and outward. If your bathroom has dark corners (e.g., the shower area), consider keeping an auxiliary ceiling light. For makeup or shaving, stand 40–60 cm away for shadow-free, even lighting. Choose a version with CRI ≥90 for accurate color rendering

A: Hardwire installation is more involved than a plug-in mirror because it requires handling in-wall wiring. Best case: Pre-wired 86-type junction box at the mirror location during construction. If no pre-wire exists:

• Run wiring from a nearby outlet through in-wall conduit or surface-mounted raceway

• Alternatively, convert to a plug-in version (check if the product supports this)

A licensed electrician is strongly recommended — especially in bathrooms where moisture and grounding are critical. We do not recommend DIY wiring

A: This product typically comes in two lighting styles:

• Backlit: Light shines from behind the mirror onto the wall — a soft halo effect, no direct glare

• Edge-lit: Light emits forward from the perimeter edge, providing facial illumination

Some models combine backlit + front-lit for versatility. If you’re concerned about glare, choose a model with a frosted diffuser layer or dimming function — brightness can be adjusted to a comfortable level. Although “dimmable" is not explicitly in the title, many similar products support dimming — check the specifications.

A: Yes. This mirror is designed specifically for bathrooms with:

• IP44 rating: Splash-proof and moisture-resistant

• Potting/sealed driver: LED driver is potted (encapsulated) to prevent moisture short-circuits

• Moisture-resistant back coating: Anti-rust paint on the rear

• Low-voltage LEDs: Typically 12V or 24V, stepped down by the driver for added safety

Installed in zone 2 (at least 60 cm / 24 inches from the shower head), expect a lifespan of 5–8+ years. Never directly spray water onto the back of the mirror.