Thermal Bridge Break External Insulation Anchor with Nylon Isolated Metal Screw and JG/T366 2012 Compliant Hammer Drive Fastener
MJL‑GZ‑01 Thermal‑Bridge‑Break External Insulation Anchor is a hammer‑driven fastener specially designed for passive house projects. Equipped with nylon‑isolated metal screw structure, it effectively cuts off thermal bridge conduction and reduces building heat loss.
Hammer‑in installation optimizes field‑working procedures and boosts construction efficiency. With excellent anti‑aging and shock‑resistant performance, this anchor complies with JG/T366‑2012 and passive‑house insulation anchor standards.
Widely used to fasten EPS, XPS and rock‑wool boards for passive houses and ultra‑low‑energy‑consumption buildings.
- 8-series, 10×185 and 10×205: 200 sets per carton
- Long sizes 10×255-10×405: 100 sets per carton
| Substrate Material | Minimum Load Capacity |
|---|---|
| C25 Concrete | ≥1.0 kN |
| Solid Brick | ≥0.8 kN |
| Perforated Brick | ≥0.6 kN |
| Aerated Concrete | ≥0.4 kN |
Official test reports can be supplied upon request.
- Drill holes on wall with pre‑bonded insulation boards
- Insert anchor sleeve
- Strike the pin with hammer until flush with wall surface
This provides a reliable fixing solution for large‑scale passive‑house and high‑energy‑saving building insulation construction.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.