VR10 Single 10" Line Array Speaker with neodymium drivers lightweight design

VR10 line array loudspeaker is a compact 2-way system. It offers a frequency range of 80Hz–18kHz with smooth frequency and phase response. Consisting of two imported 44-core neodymium magnet compression drivers and one 10-inch neodymium magnet woofer, it forms a high dynamic headroom combination, significantly reduces cabinet weight, and provides an extremely high SPL-to-volume ratio.

The low-mid section of VR10 uses a 300W 10-inch paper-cone neodymium magnet woofer. A specially designed midrange phase plug is installed at the front of the driver to avoid interference caused by comb filtering in the midrange and optimize midrange directivity.

The high-frequency section employs dual 44-core neodymium magnet compression drivers combined with a planar wave transformer to generate a consistent wavefront. The high-frequency assembly with up to 110dB sensitivity is composed of dual 44-core neodymium magnet compression drivers, a waveguide, and an exponential horn.

The ultra-compact cabinet of VR10 delivers a peak SPL output up to 133dB.

The VR cabinet is trapezoidal, with minimized gaps between enclosures to reduce ineffective radiation areas of the entire array and minimize vertical lobes.

Each cabinet offers adjustable angles of 5° in 1° increments, plus 6.5° and 10°, totaling 8 positions. When flying up to 16 units, the rigging hardware provides a 7:1 safety factor.

The cabinet is constructed of 18mm front panel and 15mm side panel birch plywood, finished with wear-resistant black textured waterproof paint.

Two recessed handles flush with the cabinet are mounted on both sides for easy handling.

The rear connection panel is equipped with NEUTRIK NL4MP four-pin connectors: 1+/1- for high-frequency drivers, 2+/2- for the woofer.