Adsorption Air Dryer

Compression heat adsorption dryer Features The waste heat dryer uses the waste heat of the oil-free air compressor to heat and regenerate the adsorbent, making full use of the waste heat in the compressed air system. Under the condition that the heating device is not applicable, the effect of the heated dryer can also be achieved, fully demonstrating other energy and high efficiency characteristics, and the dew point of the finished product can reach -40°C. It adopts its own

Adsorption Air Dryer Blast thermal adsorption drye Product features are controlled by PLC: The controller adopts the PLC controller (patented product) independently developed by our company, which makes the equipment run more stable, has higher reliability and has stronger ability to withstand interference. principle: Adsorption drying process: Compressed air containing moisture flows through an adsorption tower equipped with high-performance adsorbent. The moisture in the

Adsorption Air Dryer Freezing-adsorption combined air dryer Hongjinli Company's BC series energy-saving freezing-adsorption combined low dew point compressed air drying device is a new type of compressed air drying device. It is an organic combination of a freezing dryer and a microthermal regeneration dryer. The two There is a close and inseparable internal connection with the word flow setting. The combined dryer adopts the newly developed drying process. It is different

Adsorption Air Dryer Features 1. According to dual thermal/hydraulic calculations, the tower bed resistance is small, and the contact time between compressed air and desiccant is greater than 5 seconds, ensuring the dew point requirements of the exported finished gas. 2. 30% desiccant balance is used to compensate for the natural aging of the desiccant and ensure the drying effect. 3. Large diffuser ensures that the air flow passes through the desiccant layer evenly and

Adsorption Air Dryer heatless/micro heat (LH) regenerative adsorption dryer technical parameters model air treatment(m3/min) Pipe diameter(mm) Dimensions(length x width x height mm) Heating power/power supply (micro heat) Equipment weight (heatless Kg) Equipment weight (micro heat Kg) BX0005 0.8 DN15 600X350X1500 　 70 　 BX0010(LH) 1.8 DN20 650X450X1500 0.35/220 80 95 BX0020(LH) 2.8 DN20 700X450X1500 0.5/220 100 120 BX0030 (LH) 3.8 DN25 900X480X1600 0.75/220 130 140 BX0040(LH)

Adsorption Air Dryer 1. Work flow of heatless regeneration adsorption dryer The heatless regeneration adsorption dryer uses a pressure swing adsorption regeneration cycle to exchange compressed air through two drying cylinders A and B filled with adsorbent, that is, when one cylinder absorbs water vapor under a high partial pressure (working pressure) state , the other drying cylinder analyzes at low partial pressure (accepts atmospheric pressure), and then switches according