Vacuum Cleaner Test System To Test Vacuum Cleaner Performance European Standard According To Standard IEC 60312 HJ0641

Standard :IEC60312 clause2.1.5 fig1,clause 2.1.2 fig2,clause 2.1.3 fig4,clause 5.2.2 fig5,clause 5.2.3 fig6,clause 5.2.4 fig7a,7b,7c,7d .

Application: It is used for the manufacturers and testing organizations to test the vacuum cleaner.Test parameters: the voltage of vacuum cleaner ,the current ,input power , power factor, suction power, flow rate, vacuum and efficiency

Test sample: Vacuum cleaner

Feature:

1.According to European standard requirements, European standard A test method for throttle valve, control valve opening size, a total of 15 points

2,Inflatable chamber (uniform pressure box): European standard size and material according to standard IEC 60312 in the 5.2.8.1 (A) design

3,Test tube: in Europe standard, the test pipe is formed by throttling valve and steel pipe, and the measuring accuracy is + 2%

4,Voltage AC(10V～300V),Accuracy:0.5%

Current AC(0.01A～20A),Accuracy:0.5%

Flowmeter(0.5～5) CBM/min Accuracy:±1%

Vacuum pressure gauge: (0～-50)Kpa ,Accuracy:±1%

5,Temperature compensation and correction: The European standard is modified according to standard air density in accordance with 5.2.8.4 of IEC 60312.

Basic test process:

1.Conforms to the requirements of IEC 60312 clause 2.8)

2.Place the vacuum cleaner on the test bench and transfer the test voltage to + 1% rated voltage and + 1Hz rated frequency. First, run 10 minutes to establish a temperature reference value for the release gas for measurements at each point below. For each measuring point, measure after 1 minutes after throttling, and then vacuum cleaner opens again to achieve reference conditions. You can check the temperature of the gas released by the vacuum cleaner

Configuration list:

Pictures for reference :