Water - Cooled Diesel Generator Controller With CE / ISO Certification

Performance and characteristics:

HGM400 series controller has two variants:
HGM410: Automatic Start Module, it controls generator to start/stop by remote start signal;
HGM420: Based on HGM410, add mains AC monitoring, mains/generator automatic switching control (AMF), especially suitable for automatic control system composed by mains and generator.

132x64 LCD with backlight, optional language interface (Chinese, English, Spanish and Russian), push-button operation;
Adapt to 3 phase 4 wire, single phase 2 wire, 3 phase 3 wire and 2 phase 3 wire (120/240V), 50/60Hz power supply;
Can measure and display 3-phase voltage, 3-phase current, frequency, and power;
For mains: Over/under voltage, lack of phase; for generator: over/under voltage, over/under frequency, over current;
Precision measure and display engine parameters,
Control protection: Automatic start/stop, switch on/off (ATS control) and fault display;
With ETS, idle control, pre-heat control, acceleration and deceleration control, all are relay output;
Parameters setting: Allow user to modify parameters and store them in internal FLASH, which cannot be lost even when power off. All the parameters can be adjusted from the front panel, or by PC via an SG72 adaptor;
Types of temperature and pressure sensor can be directly used and user defined;
Conditions of crank disconnect can be selected.(magnetic pickup, oil pressure, generator);
Power supply range is (8~35)VDC, accommodating to different starting voltage;
All parameters use digital modulation, abandoning analog modulation of conventional potentiometer, more reliability and stability;

Our Main Product:

1. Diesel Generating Set
2. Gasoline Generating Set
3. Gas Generating set
4. Mobile Light Tower
5. Forklift
6. Air Compressor
7. Control System
8. Standard Control Panel
9. Auto Control Panel
10. Auto Parallel Control Panel
11. ATS
12. Brushless Alternat