Edge Forming Machine For Ceramic Band Heater Capable Of Rolling 25mm Wide Steel Strips

SAFETY

Pay attention to electricity safety.

During operation, keep your hands away from the gear.

The equipment must be placed on a flat ground during installation and cannot be shaken.

INTRODUCTION

This machine presses the metal sheet into a corrugated shape, which is used for the edging of the ceramic band heater.

OPERATION INSTRUCTION

1. Power on, start switch

2. Prepare the metal sheet that need to be formed, and select the control speed.

• Insert the metal sheet into the front of the gear and push it along the gear from beginning to end.

• Turn off the power after use.

Please see the attachment for the operation video.

SHIPPING LIST

One main unit, One power cable, One spare gear (one set contains two gears)

MAINTENANCE

1. After the gear is worn, the gear should be replaced in time

2. In terms of daily maintenance, it is necessary to clean the iron filings on the gears every day.

STORAGE

Pay attention to waterproof and moisture-proof.

TECHNICAL DATA