Window Type Zero Sequence Current Transformer ISO Certificated Engery Meter Applied
High Quality Zero Sequence Current Transformer for Engery Meter
Introduction
Current transformers typically consist of a silicon steel ring core wound with many turns of copper wire as shown in the illustration to the right. The conductor carrying the primary current is passed through the ring. The CT's primary, therefore, consists of a single 'turn'. The primary 'winding' may be a permanent part of the current transformer, i.e. a heavy copper bar to carry current through the core. Window-type current transformers (aka zero sequence current transformers, or ZSCT) are also common, which can have circuit cables run through the middle of an opening in the core to provide a single-turn primary winding. To assist accuracy, the primary conductor should be centered in the aperture.
PARAMETERS
| Technical parameters | |
| Standards | IEC60044; IEC 61869; ANSI/IEEE C57.13 |
| Rated primary current | 50-600A |
| Rated load | ≤30VA |
| Rated frequency | 50Hz or 60Hz |
| Rated secondary current | 5A or 1A |
| Rated short-time thermal current | 40kA, 1S |
| Rated dynamic current | 63kA |
| Rated insulation level | 12/42/75KV |
| FS | ≤10 |
| Mechanical parameters | |
| Material | Epoxy resin |
| Weight (kg) | 15 |
| Operating conditions | |
| Operating temperature | -10°C to +55°C |
| Daily average temp | <+40°C |
| Storage temperature | -40°C to +70°C |
| Altitude | <1000 meters |
| Condition | No existence of severely begrimed, erosive and radioactive gas in the air. Permission of long-term operation under rated current. |
| Rated Current Ratio | Accuracy Class | Rated Output(VA) |
| 50/1 | 10P5 | 2 |
| 60/1 | 2 | |
| 75/1 | 2 | |
| 100/1 | 2 | |
| 150/1 | 10P10 | 2.5 |
| 200-300/1 | 2.5 | |
| 400-600/1 | 2.5 | |
| 50/5 | 10P5 | 2.5 |
| 75/5 | ||
| 100/5 | 2.5 | |
| 150-300/5 | 10P10 | 5 |
| 350-600/5 | 5 |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.