Metal plate straightening machine, zigzag coil feeder, NC feeder
NC feeder failure analysis
 
Mechanical aspects:
 
(1) The NC feeder's rolling bearing is stuck and causes an alarm. The detection method is: servo off, and then manually rotate the feeding roller under no-load conditions. If there is obvious jam or unsmooth phenomenon, it means the bearing is faulty.
 
The failure rate is also relatively low, generally does not appear, if it occurs, the bearing must be replaced.
 
(2) After the customer replaces the mold, the height of the lower mold is inconsistent with the height of the last mold or the length of the positioning pin is inconsistent, which causes the relaxation time to be delayed, causing the positioning pin to stretch the material and alarming. This probability is large.
 
The detection method is: manual control of the slow decline of the punch, careful observation of the drum relaxation time, repeated detection, that is, the problem can be found. Solution: Adjust the relaxation time; reduce the NCF feed height to be flush with the mold or about 3mm lower.
 
(3) If the material is replaced, the thicker material is used, and then the limit block is added in front, which may also cause an alarm phenomenon. The probability is small and it is not easy to appear, and the customer can find it by himself.
Products:
 


 
Specification:

Straigtening performance:
 

*1:(Pneumatic):Option in case of pneumatic mandrel expansion is provi