Fully Automatic Feeder Line Uncoiler Straightener Feeder Machine for Spare Parts Stamping

1. Before the roller feeder is running daily, it is necessary to carefully check the feeder first to ensure that there is no chipping or foreign matter in the gear contact part, the cross joint is not worn, the contact surface of the loose shaft is not worn, the pressure plate is not blocked, and The bolts of each component are not loose.

2. After the press is changed, the adjustment screw on the mounting plate should be adjusted to the roller feeder to adjust the feeding height. The adjustment principle is slightly lower than the lower mold of the comparable mold, and the material cannot be introduced into the mold guide column first. Adjusting the height of the feeder, this method can easily damage the mold.

3. Before running the feeder, it is necessary to carry out the trial die after the normal operation, and then carry out continuous stamping and feeding. During the operation of the feeder, it is necessary to pay attention to whether the delivery distance is accurate and whether the material is skewed. If it is found that there is abnormal feeding, it should be stopped immediately for inspection and re-commissioning.

4. After the delivery of a roll of material is completed, it is necessary to stop the punching machine in time to prevent the punching machine from accidentally hitting the mold.

5. It is necessary to regularly lubricate the roller feeder. For the wear and tear of spare parts caused by long-term work, it is necessary to contact Ruihui mechanical technicians for replacement.

Specification:
 

Straigtening performance:
 

*1:(Pneumatic):Option in case of pneumatic mandrel expansion is provi