Auto Parts Stamping Processing, MAC Feeder, Material Leveling Adjustment, punch machine coil
 

Ruihui feeder sets feeding, correction, material rack three-in-one automatic feeding device,Ruihui MAC feeder head debugging.
1. Feed roller pressure adjustment: By adjusting the pressure regulating valve, the upper roller and the lower roller can be prevented from slipping, and the pneumatic pressure is controlled at the same time to avoid crushing the material, causing indentation or slipping phenomenon.
2. Material offset: If the material starts to be offset incorrectly, it should be immediately confirmed whether the mold is parallel and placed in the center of the table. Whether the material enters the leveling machine at right angles and in the middle, this operation can be measured by the gage, if there is a slight irregularity You can slowly position by adjusting the left and right positions of the stopper wheel.
3. material leveling adjustment: material leveling principle: the leveling drum is arranged in a zigzag pattern, if the flattening roller on the inlet side is put down, the material is bent along the drum, if the flattening roller on the outlet side is pressed too much The material is bent downwards.
Generally, the inlet side is lowered to a position where the upper and lower flattening roll gaps are 1 to 1.5 mm smaller than the material thickness, and the outlet side is adjusted to be the same as the material gap (ordinary material).

Specification:

Straigtening performance:
 

*1:(Pneumatic):Option in case of pneumatic mandrel expansion is provi