Hydraulic Power Pack Work with Double Acting Cylinder Remote Control 220 Voltage

Application:

Offshore Oil and Gas

Marine and Deck Equipment

Lifting Equipment

Industrial

Test Equipment

Standard Features of our power pack design:

· Driven by Continuous-duty rated electric motor or diesel engine

· Modular Type of integrated manifold block to eliminate as much hard piping as possible.

· Built for industrial, marine and offshore oil and gas application.

· Pump control in an opened-loop circuit (suction circuit), in closed-loop circuit (boosted circuit) and semi opened-loop with make up.

· Hydraulic control system with constant displacement pump, variable displacement pump, load sensing & variable displacement pump, load sensing & constant displacement pump and system with secondary control.

· Design pressure range into 3,000Psi, 5000Psi, 6000Psi and up to 10,000 Psi (690 Bar).

· Proper piping, filtration and cooling system design.

Low-height cylinders are built to provide the maximum power to height ratio and are ideal for confined spaces where other cylinders will not fit. The cylinder is another type of low-height cylinder engineered with mounting holes for easy installation.

1. Can I use double acting cylinder with this unit?

    Yes. But some mode just for the single acting cylinder.

2. How is it mounted. I don’t see any brackets or mounting plates?

(1) There are two mounting holes on the bottom of the block that are 3-1/4" inch apart. The thread size is 3/8" 16TPI.

(2) There are threaded holes on each side and bottom of the metal block in front of the pump.

3. What fluid should be use in this unit?

The recommended fluid for this power unit is ATF (automatic transmission fluid) DEXRON-III.

Warranty:
We offer 12 months warranty.