Technical parameter of equipment

Driving mode:hydraulic drivenSqueezing direction:For cylindrical batteries, the longitudinal axis of piercing the battery shouldbe parallel to the two plate of the extrusion device

As for square and soft battery, pierce the battery only at the center section of the wide side.

As for the coin type or button type battery,pierce in a way that the upper and lower planes

of the battery are parallel with the plate.

Design specification for main components of equipment:

Control scheme :control the sensors, provide with closed loop response

travel switch, interpret the sensor output signal

Sensor:calculate the needle stroke and linear speed by pulse signal

Hydraulic pressure station :provides stable pressure and power source with variable speed .High

power motor and domestic high quality pump provide with stable output. Overflow valve ,

solenoid valve and pressure release valve provide with variable-speed power

Mechanical section:chromium plated high performance high carbon steel constitute two

main sections of the transmission support, the test trip: 500mm ;

Safety protection system

1,Overvoltage protection :the sensor has a built-in pressure range, which can prevent the damage

to the sensor effectively and the drive motor due to excessive pressure

2,Phase loss and anti-phase protection switch

3,Travel limit protection

4,Circuit fuse overcurrent protection

5,Overload protection

Service condition:

1,Ambient temperature :25±5℃

2,Power supply condition:Three-phase four wire electric source

Basic subassembly list:

Equipment configuration list:

1,Test host : 1 set

2,Standard extrusion plate: 2 set

3,Factory certificate : 1 piece

4,product specification: 1 piece