Wet Proof Anti Interference High Frequency Spark Tester , Cable Testing Device

Specifications:

Test Voltage:1.0~15.0KV. Cable Diameter: 0~25mm. Output Frequency: 2.5-3.5KHz normal. Fast recovery time after fault (0.1s)

The Sine Wave Spark Tester is a fast and reliable instrument used in distinguish wire faults and detecting bare wires. Its high-speed fault detection feature gives you prompt information without worsening the condition of the wire after the test.

The use of high frequency (3KHz) enables a traditional commercial power frequency bead chain electrode to be shortened to 120mm HS015E Model.

The Sine Wave Spark Tester is quality-assured to meet your needs.

Basic Function

• Fast recovery time after fault (0.1 second).
• Occupies short space in line and with improvement factor of 50 compared to
• traditional CT power frequency electrode.
• Voltage Display: 0.0~15.0KV digit, 14.2mm LED display, Accuracy +/- 1% of reading
• Output Control: Front Panel Reset in Manual Mode. Closure time is selectable
• 0.2s/2s/5s in main board by jumper JP, Form C relay contacts (250VAC/5A) for all
• wire faults detected.
• Limits the fault current without damaging the test equipment.
• Short exposure time to corona does not degrade nor damage good insulation.
• Distinguishes all wire faults and detects bare wire.
• Safety Switch interlock.

Basic Specification:

*Follow UL 44, any point on the wire being traveled for not less than a total of 18 positive or negative crests of the supplied voltage.