JGY-HS High Speed Corrugated Box Printing Machine Price 300 Diameter

Lead Feeder Part 

1.electric control machine from the alarm bell, continuous ringing warning, to ensure the safety of workers.

2.drive shaft with friction clutch, to avoid misuse and damage to the machine.

3.pneumatic interlock device.

4.The host motor starts the protection device. (The machine is not locked, the host can not start running)

Feed roller

1. up roller use the soft rubber shaft ,so when feed the board ensure the not borken the board Diameter 132mm, wearing rubber shaft , make the blance correct ,keep the paper feed steay and accurate.

2.The lower feed roller with embossing roller diameter ¢ 175 mm, seamless steel pipe, embossed hard chrome plating.

3.feeding roller cross slider-type dial dial manually adjust the adjustment range of 0 ~ 12 mm. Adjustment does not affect the gear gap, to ensure transmission accuracy.

4.hand-type quick clearance fine-tuning self-locking device.

automatic zero device

1.The paper feed section, the printing section, and the slotted part are automatically reset to zero.

2.General carton use automatic zero device, try to print two can be adjusted to the correct position to reduce cardboard waste.

Printing department

Feed the upper and lower rollers

1.on the roll: diameter ¢ 71 mm seamless steel pipe, with three paper feed ring.

2.the next roll: diameter ¢ 134.6mm seamless steel pipe, surface grinding, hard chrome plated

3. feeding roller cross slider-type dial dial manually adjust the adjustment range of 0 ~ 12 mm. Adjustment does not affect teeth Wheel clearance, to ensure transmission accuracy.

steel anilox roller rubber roller set ink system

1.diameter of ¢ 176mm.

2.steel surface grinding, repression reticulate, hard chrome plating.

3.alance correction, smooth operation.

4.mesh number is 180,200,220,250 lines / inch selection. Option ceramic roller 300line/inch

5.with the feed system pneumatic automatic lifting device. (When feed paper pr the anilox roller is lowered and touched with print plate ,stop feed paper anilox roll is up and the plate is separated)

6.Anilox roller with wedge-type clutch, even ink, easy to clean ink.

7.rubber roller diameter ¢ 186 mm.option the doctor blade system

8.steel pipe surface wrapped with wear-resistant rubber, and do the balance correction.

9.rubber in the special high grinding, ink transfer effect is good. Quick clearance fine-tuning self-locking device to ensure uniform ink. The amount of uniform ink system, the conversion effect is good, to extend the life of rubber roller.

Machine date