Construction Sites 2000KG Per Cage Rack And Pinion Hoist
Construction Sites 2,000KG Per Cage Rack And Pinion Hoist
Rack And Pinion Hoist Introduction
1. Smooth, strating and braking cause no impact.
2. Lifting speed can be controlled.
3. The starting current is less than the rated current.
4. Mechanical wear is reduced. Thanks to zero impact in start-up, it greatly reduces the mechical wear of gears and racks and the brake wear is obviiously reduced.
5. It has significant energy saving effects.
Rack And Pinion Hoist Configuration
There is a electrical small crane available to facilitate the assembly of columns and doors on the floors.
Available in single or twin hoist cage configuration.
The construction rack and pinion elevators are Variable Frequency Drive (VFD), with low starting current and much less wear and tear, very smooth starting and stopping.
Manual or Automatic Controls of the hoist is optional.
Lighting inside construction elevator car is LED ceiling lamp
The construction material hoist cage roof doors are equipped with Interlock.
Equipped with hoist drop test facility with remote control.
Rack And Pinion Hoist Parameters
| Item & Article No. | SC200BG, KP-B11; SC200/200BG, KP-B12 Rack And Pinion Hoist |
| Payload Capacity | 2,000KG per Cage |
| Lifting Speed | 0–60 meter/minute. |
| Max. Lifting Height | 450 m |
| Cage Size (internal) | 3.2(Length)*1.5((Width)*2.35(Height) meter |
| Motor Power | 3x15 KW per Cage |
| Motor Control | Frequency Control (FC) |
| Invertor Power (KW) | 1*55KW per Cage |
| Gearbox | PIELI Helical Gearbox |
| Anti-drop Safety Device | Centrifugal Brake |
| Power Supply Range | 380–500 V, 50 or 60 Hz, 3 Phase |
| Mast Section | Square Column 650*650*1508 mm with Bolted Rack |
| Rack module | 8 |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.