High Power 3.2V 75Ah Flat LiFePO4 Battery Pouch Cell for Motorcycle

High Power 3.2V 75Ah Flat LiFePO4 Battery Pouc Cell for Motorcycle

Advantage of 3.2V 75Ah Cell  

a. High energy density

b. easy to install

c.  Long cycle life more than 2000 @ 80%DOD.

d.  Low self discharge < 3%.

e.  98% efficient.

f.   Fast charging is available (can up to 3C, less than 20 minutes).

g.  High Discharge Current, 1C is standard, higher currents are also acceptable up to 3C continuous with negligible loss in efficiency and cell life.

h.  Light weight and small volume, around 1/3 weight and volume of lead-acid battery.

i.   No cobalt – no toxicity – no hazards.

Specification

Company advantages

1)  More than 10 years of exporting experience.
2)  Advanced and rich experience R&D technology team from china top 5 university.
3)  Competitive price
4)  Best service within 24 hours.

5)  Small order is accepable

6)  1-2 pieces sample could be offered for testing our quality.

7)  Prompt delivery

Quality and Guarantee

For our lithium batteries, we assure do safety test as below to guarantee good quality.

1. Impact test, a cell is to be placed on the impact flat. A Φ15.8mm bar is to be placed on the center of the cell. A 9.1kg weight is to be dropped from a height of 610mm onto the cell, the distortion is allowed. No fire, no explosion.
2. Overcharge test, a cell is discharged to cut-off voltage at CC of 0.2C. Then it is to be subjected to CC/CV power by connecting its positive & negative terminal, then set the current as 3C, the voltage as 10V, after that, charge the cell up to 10V at CC of 3C, until that last 7h at the voltage of 10V or the voltage is no more increased. No fire, no explosion.
3. Crush test, a cell is to be placed on the crush flat, the axis is parallel to the crush flat, It is to be crushed between two flat surfaces. Crushing force is approximately 13 KN and hold for 1 min. No fire, no explosion.
4. Nail penetration Test, a cell is to be penetrated completely the center of the largest side at the speed of 20-40mm per second by a Φ3.0mm stainless steel nail. No fire, no explosion.
5. Heating test, a cell is to be heated in a circulating air oven. The temperature of the oven is to be raised at a rate of 5℃±2℃ per minute to a temperature of 130℃±2℃ and remain for 30min at that temperature before the test is discontinued. No fire, no explosion.
6. Short-circuit test, a Cell is to be short-circuited by connecting the positive and negative terminals of the cell with copper wire having a maximum resistance load of 50mΩ. Monitor its temperature while testing, the cell is to be discharged until the cell case temperature has returned to be 10℃ less then peak temperature. No fire, no explosion

Packaging

Application 

 Electric bicycle, electric motorcycle, electric scooter, electric unicycle scooter, solar power system, electric golf cart etc.