Carbide ball nose end mill for Aluminum, ball end mill bits, 2 flute carbide end mill,drill mill end mill

Specification:

1,2 flutes ball nosed end mills, Made from high quality virgin material solid carbide rod, 9% , 10% or 12% cobalt content, grain size 0.2μm to 0.8μm . Coated by TiSiN, nACo4, TiCXSiN,nACo4-blue coatings or no coating, suitable for maching 45 to 65HRC materials, such as steel, carbon steel, pre-hardened steel, cast iron, stainless steel,titanium alloy etc.

2,Produced by skilled workers with precise or ROLLOMATIC 5-axile grinding centers.The cutting edge is very sharp, the chip groove is large, and the end arc is perfect.

3,The use of good quality new ultra-fine grain size of tungsten carbide material(Top carbide in the market GESAC is applied) enable the ball nose end mill with high wear resistance and strength, performs good in high-speed cutting applications.

Popular standard size(Can be available from stock, ready to ship):

End mill Coating: The correct tool coating can have a great impact on the cutting tools by increasing the cutting speed, tool life or improving the surface finish. Synthetic diamond (PCD) is a special hard coating used for cutting tools which must withstand high wear resistance. The tool life of PCD coated tools can be up to 100 times longer than that of uncoated tools. However, the coating cannot be used at temperatures higher than 600℃ or on ferrous metals. Diamond coating is applied for some end mills for aluminum, AD coating or DLC coating. Both are Balzac coating. Most Betalent carbide’s coatings for end mill are Balzac coating. Common coating materials are TiSiN,TiCXCo4, nACo4, nACo4-blue,TiAlSiN.