ISO9001 75m/S Rendering Plant Crusher For Chicken Bone

Rendering Pre-Breaker Model Is JSPSA-1226 Rendering Plant Crusher

1,Crusher is used for crushing the whole animal carcasses, and various internal organs and bones from slaughterhouses.

2,Generally use crusher to reduce the size of the material and then delivery by screw conveyor or vane pump before cooking.

3,The motor model and the speed of the crushing shaft can be adjusted according to the production demand, the operation cost is low.

4,The design of quick repair and replacement parts makes the crusher more efficient.

Structure

1. Impeller: The impeller accelerates the material to a speed of 60-75m/s and ejects it, and impacts the material lining in the vortex crushing chamber for strong self-crushing. There are up and down flows between the cone cap and the wear block. The track plate protects the impeller from wear. 5. Main shaft assembly: The main shaft assembly is installed on the base to transmit the power from the motor through the V-belt and support the impeller to rotate. The main shaft assembly is composed of a bearing seat, main shaft, bearing, etc.

2. Base: The vortex crushing chamber, main shaft assembly, motor, and transmission are all installed on the bottom seat. The base structure is shaped. The middle part is a quadrangular prism space. The center of the quadrangular prism space is used to install the main shaft assembly. Discharge channel.

3. Bracket: According to the different working places of the crusher, open-air operation or suffocation operation can be considered with or without a bracket.

4. Transmission device: a belt drive mechanism driven by a single motor or dual motors (above 75KW, dual motor drive), dual motors drive two motors installed on both sides of the main shaft assembly, the two motor pulley belts and the main shaft pulley Edge, balance the forces on both sides of the main shaft without generating additional torque.

5. Lubrication system: The special grade centralized lubrication of Mobil grease is adopted. The lubrication parts are the upper bearing and the lower bearing of the main shaft assembly. In order to facilitate the oil injection, the oil pipe is used to lead the machine to the outside of the machine for regular oil pumping.