60Hz Conveyor Feeder Hopper 1100W Power For Multiapplication

Customized Voltage Auxiliary Brewing Equipments / Flexible Screw Feeder

Product introduction

Product Features

Evenly mix different materials and effectively avoid material stratification during conveying process

Motor-driven screw ensures low noise level in operation

Fully closed conveying line, effectively avoid material contamination in the conveying process

Stainless steel made screw, easy for installation and maintenance

Reverse phase protector is pre-installed to avoid that the motor is incapable of conveying materials because of motor reversal

The length of conveying pipeline can be determined by customer’s needs

The auger and casing is typically selected next based upon the customer rate requirements and material characteristics. Conveyor sizes range from 2.5 inches up to 8 inches as shown in the chart below. In addition augers offered include flat wire, bevel edge, square bar, and round wire. Our technical specialists will help in selecting both of these items to make sure that we meet your conveying goals.

The discharge box is generally setup for a 45 degree discharge however we offer 0, 15, 30, 45, 60 and 90 degree discharges which is dependent upon conveyor diameter and the customers layout. The drives that provide the auger rotation include both in-line ratio multipliers and right angle gearboxes. Right angle gearboxes are usually selected where headroom is an issue and if a very low auger speed is required. Typical auger rotations range from 60 to 350 RPM. There are many options for motors including standard TEFC, premier efficient, wash down duty, inverter duty and various explosion proof models.