TOPCON 12V 50W ACP-8

PN 46201 64610A 12V50W Vision Projector Lamp new

►Quick Detail:

TOPCON 12V 50W ACP-8 PN 46201 64610A 12V50W Vision Projector Lamp new

This light source bulb has the characteristics of high brightness, low attenuation, and stable performance. It has low cost and moderate lifespan, around 5000 hours. Traditional light sources are the most common type of projector light source. With a century long development history of light bulbs, the technology is relatively mature, and it has a wide range of applications and excellent brightness, often reaching a brightness of 3000. The brightness and color of the projected image are not only determined by imaging technology, but also influenced by the light source. So when choosing a light source bulb, it is necessary to choose the correct light source bulb.
For example, the light bulb projectors commonly seen in conference rooms widely use this technology. Currently, traditional light sources can mainly be divided into metal halide lamps, UHP and UHE (ultra-high pressure mercury bulbs), xenon lamps, and other high-pressure gas discharge light sources. The core imaging part of the projector includes a spectroscope and three independent LCD panels. The spectroscope splits the white light emitted by the light source into three primary colors: red, green, and blue, and displays each color through three LCD panels. Each LCD panel has millions of crystals, and the crystal states of opening and closing, as well as half opening and half closing, are configured to allow light to pass through and display colors in pixels. Finally, by combining the three primary colors of red, green, and blue through a prism, a specific image can be presented. When planning to replace the light bulb, you can first read the manual, remove the old light source, install a new light source, and adjust the image settings if the image is not clear.

►Steps for replacing the projection light bulb:

1. Firstly, it is necessary to prepare a spacious, clean, and insulated tabletop, as replacing light bulbs requires a clean tabletop so that removed parts will not be disturbed.
2. Remove all removable screws until you see the LED main bulb. Nowadays, high-power LED beads are used to replace metal halide beads.
3. Ensure that your machine has the same model and specifications as the LED chip you purchased.
4. Install all removed screws and reset all screws.
5. Do not directly pick up the LED beads with your fingers, wear ultra-thin gloves；

6. When replacing old light bulbs, please pay attention to protecting the environment and avoid littering. Put it in a dedicated trash can.

7. Regularly check the newly replaced bulb light source to ensure stable operation.

►Key features: