GE LOGIQ BookSeries Ultrasound Dedicated Lithium-ion Battery Pack SH-250 14.8V 5200mAh

GE LOGIQ BookSeries Ultrasound Lithium-ion Battery Pack SH-250 14.8V 5200mAh

► Brief Description

The SH-250 battery pack features a voltage of 14.8V, a capacity of 5200mAh, and an energy rating of 77Wh. It is a rechargeable lithium battery that takes 4–5 hours to fully charge and supports 500 charge cycles; it is designed for use with the GE LOGIQ Book series ultrasound systems. Its high-capacity design enables the LOGIQ Book system to perform continuous scanning for approximately 4 hours on a full charge. The battery incorporates multiple intelligent safety protections—including safeguards against over-voltage, over-current, short-circuits, and overloads—to effectively prevent risks associated with abnormal charging/discharging, excessive temperatures, or circuit malfunctions. The casing is constructed from durable, eco-friendly, and flame-retardant ABS+PC alloy, and the unit is equipped with an intelligent management chip . This battery has obtained several authoritative international certifications, including CE, UL, RoHS, and ISO 9001/9002 quality management system certification.

► Specifications

►Detailed Photos

►Battery Maintenance Recommendations

1.The lifespan of a lithium battery is typically measured in complete charge-discharge cycles (approximately 400–600 cycles). It is recommended to perform a full charge-discharge cycle periodically to maintain cell activity.

2.If the LOGIQ Book ultrasound system is not used frequently, remove the battery during periods of prolonged inactivity. Store the battery in a cool, dry environment; the optimal storage temperature range is -20°C to 60°C.

3.If you notice any unusual odor, abnormal heat, deformation, or discoloration during use, stop using the device immediately and remove the battery. The battery contains built-in safety mechanisms; do not attempt to disassemble or modify it yourself.

4.After installing a new battery, it is recommended to perform 2–3 complete charge-discharge cycles to optimize battery performance and lifespan.

►Installation Steps

1. Power off the device and disconnect all power sources.

2. Locate the battery compartment on the bottom of the unit. Open the compartment cover, carefully disconnect the old battery's cable, and remove the old battery.

3. Carefully slide the new battery (Model SH-250) into the compartment, ensuring it is properly seated.

Securely connect the new battery's cable to the power connector.

4. Close the battery compartment cover, ensuring it is tightly shut and locked.

►To ensure optimal performance from the new battery, the following steps are recommended:

1. New batteries are shipped with approximately 30% charge. Please fully charge the battery before first use (typically takes 4–5 hours).

2. To activate the battery, it is recommended to fully charge it and then use the device until the battery is depleted and the unit shuts down automatically. Repeat this "full charge-discharge" cycle up to three times to calibrate the battery gauge.

If you want to replace the Lithium-ion Battery Pack SH-250 for GE LOGIQ BookSeries Ultrasound, please send the inquiry to me immdeiately, Looking forward to hearing from you.