MEAN WELL LOP-300-12 Power Board 12V 300W Medical Equipment Internal Power Supply Module

MEAN WELL LOP-300-12 Power Board 12V 300W Medical Equipment Internal Power Supply Module

 
 
► Brief Introduction
 

This is a built-in power board manufactured by MEAN WELL. The power board is a universal accessory with a wide input voltage range of 100-240VAC, adapting to a full range of voltage inputs. It has a DC voltage of 12W and a power output of 300W, suitable for most medical devices.

This accessory is in brand new condition, individually packaged in an anti-static vacuum bag, and comes with shockproof red corrugated foam and a kraft paper box to prevent damage to the circuit board from static electricity during transportation.

 
 
► Features

1. Medical-grade stable DC output

Converts AC mains power to 12V DC power, complying with medical equipment electrical safety regulations. It features low output voltage ripple and stable power supply, ensuring reliable operation of internal modules in the medical device and preventing equipment errors caused by voltage fluctuations.

2. Circuit safety protection

The circuit board has multiple protection devices, such as overvoltage protection, overcurrent protection, short circuit protection, and overheat protection. In the event of an abnormal leakage or short circuit, the power supply can quickly lock and cut off the output, protecting both the power board itself and preventing damage to other internal circuit boards.

3. Wide Compatibility

Supports 100-240V universal AC input, maintaining stable output even in environments with fluctuating mains voltage. Compatible with various domestic and international medical devices, suitable for original equipment manufacturer (OEM) installation and overseas repair/replacement.

4. Easy Installation

Open circuit board structure allows direct mounting inside the device chassis, saving external space.

► Parameters
 

 
 
► Product Picture
 

►FAQ
 

Q1: Can the LOP-300-12 directly replace other 12V power boards of the same power?

A1: Assuming the output voltage and power are the same, you need to check the mounting hole positions and dimensions. If the hole positions don't match, it cannot be directly installed and used. You cannot simply replace it based on voltage and power alone.

Q2: What are the common reasons for no output when powered on?

A2: First, check if the AC input power supply and connecting cables are secure; second, check if the device has a short circuit triggering the power protection. After eliminating the short circuit fault, restarting should restore operation; also check if the ambient temperature is too high, triggering overheat protection.

Q3: What should I pay attention to when wiring during installation?

A3: Isolate the AC input and DC output terminals to avoid short circuits; tighten the terminal screws to prevent equipment vibration from causing loose wiring and arcing; keep high-voltage and low-voltage wiring separate as much as possible.

90 Day Warranty                             SGS ceryification