Conventional PWM

• Support Y0-Y7 total 8 channels (please select transistor MT output);

• There are no restrictions on pulse width and cycle, both in milliseconds (ms).

Special customized PWM-analog output port

The following parameters need to be provided during customizing selection:

• The output voltage of the required PWM;

• The output frequency of the required PWM;

• Confirm the number of customized PWM, up to 4 channels of PWM can be customized (specifically, it depends on the number of analog outputs of the model selected by the customer).

• Customize whether PWM coexists with other analog quantities. (If the product is additionally equipped with analog, analog output terminals DA0~DA3 are a group, DA4~DA7 are a group. When QM3G customizes PWM, the output frequency can only be installed with other analogs in a group when the output frequency is only 21KHz ).

mView provides the function of simulating directly on the PC. You can use this function to simulate the actions performed on the HMI after planning HMI. On the one hand, it increases the convenience of finding program errors, and on the other hand, it can save downloading to the time HMI can connect to the controller. The simulation function of mView is divided into two types: [On-Line Run] and [Off-Line Run], as shown in the figure below.