Portable EV Charger with IP67 Protection 16A Max Output Current and 2.4 Inch OLED Screen

New Portable EV Charger with 2.4 Inch Screen featuring APP Bluetooth, WIFI, and RFID Card Intelligent Car Charger functionality. This Type 2 charger with Schuko plug offers a portable and simple charging solution for travel or when away from traditional charging stations.

• Max 16A output with 18-foot cable and ControlBox
• Compatible with electric/hybrid vehicle Type 2 ports
• Comprehensive protection: overvoltage, overheat, and overcurrent
• Clear charging status indicators and error display

• Date and Time display with Charging time and Consumption (kWh)
• Charging voltage / current / power monitoring with Total electricity (kWh) and Temperature
• Multi-national language selection
• Current adjustable from 6A to 16A in steps of 1A
• Appointment for charging (based on week and time)
• Automatic screen and LED turn-off according to set time
• APP remote control (Bluetooth and WIFI)
• Charging mode (RFID/APP/Password/Plug and Play)
• Charging history (up to 30 records)
• Load control, adjustable phase number and current (ModBus TCP)

The LCD brightness can be adjusted from 10% to 100%. Turn off the screen after the set delay time without touching the button. If Off-LED is enabled, the LED will turn off simultaneously with the LCD.

When PIN is enabled, PIN code needs to be entered to access the Menu, and the icon on the status display page will light up.

Three reservations can be set, with charging scheduled between start and end times. If stop charging is enabled, charging will pause upon the stop time; otherwise, it will continue until the battery is fully charged, following the week setting. After reservation is enabled, the icon on the status display page will light up.

Once Plug & Charge is enabled, you can start charging when the vehicle plug is connected, with no other authorization required.

The device can store up to 30 records, which can be viewed through the left and right buttons (turn orange and touch the button).

RFID can be added or disabled, with maximum of six cards added and saved.

The device needs to be set with wireless name and password through the APP, and you can also set static IP address. The ChargeID and URL for OCPP need to be set via the APP.

1. Successfully bind the charger with APP via Bluetooth
2. Set up WiFi to successfully connect to the network
3. Configure OCPP parameters on the settings page using the APP
4. Enable OCPP on the charger's LCD

The device can communicate through ModBus TCP in WiFi mode. After enabling load balancing, control the current during the charging process through the enabled communication mode.

1. Connect the power plug of the charger to a grounded outlet, wait for the device to enter charging standby
2. Couple the vehicle-end connector of the device to the vehicle's charging port
3. Enter the reservation page (if reservation is enabled). Swipe RFID, use APP or enter PIN to skip countdown for charging
4. Wait for the vehicle authorization signal, and then enter the charging mode

1. Stop the charging process at the controls inside the vehicle, this releases the lock on vehicle's charging coupling
2. First disconnect the connector coupled to the vehicle, then unplug the connector plug from the power socket or the charging station