Thermal Shock Chamber with Rapid Transition Technology for Automotive and Electronics
Faster Change Thermal Shock Test Chamber Rapid Change Chamber
The Thermal shock test chamber suitable for examining the ability of the whole machine, components, parts and other components to withstand sharp changes in temperature. The temperature impact test can understand the impact of the test sample once or repeatedly due to temperature changes. The main parameters affecting the temperature change test are the high and low temperature values in the range of temperature change, the holding time of the sample at high and low temperature, and the number of cycles of the test, etc.
The Thermal shock test chamber is used for testing non-heat dissipation test samples and low heat dissipation test samples. For the test of heat dissipation test samples, the heat dissipation power should not exceed the temperature control cooling capacity of the refrigeration system of the Thermal shock test chamber, otherwise it will affect the temperature conversion speed and capacity of the test chamber. It is recommended that the heat dissipation of the test samples be less than 300W.
Model:Thermal shock test chamber |
ET4200S2 |
| ET5200S2 | |
| ET6200S2 | |
| Test Space Volume(L) | 200 |
| Test Zones | 2 |
| Hot Chamber Temp.Range(℃) | +50/+200 |
| Cold Chamber Temp.Range(℃) | -75/+70 |
| Temp. Constancy(℃) | ±0.3-±1.0 |
| Temp.Homogeneity(℃) | ±1.0-±2.0 |
| Recovery Time(min) | <5(on Air Outlet) |
| Test Space Dimension(mm) | 600W*550D*600H |
| External Dimension(mm) | 1200W*2500D*2200H |
|
Temp. Range(℃) |
-40/+150 |
| -55/+150 | |
| -65/+150 | |
| Max. Specimens Weight (kg) | 50 |
| Cooling Methods | Water-Cooled(IEC 60068-3-5) |
| Power | AC380V±10%,50HZ,3/N/PE |
|
Compliant with International Standards: GB/T2423.22 MIL STD 202F (Method 107G) IEC 60 068-2-14 Test Na BS 2011 DIN 40046,Test Na JESD22-A101-A |
|
- The upper part is preheating tank (with Thermal shock test chamber door), the lower part is precooling tank, the working room is mobile metal pod between preheating tank and precooling tank,the rear part is electric control cabinet and refrigeration unit, and the main control interface is located in front of the test chamber door. The gate is opened in the width direction, and each slot area is equipped with independent circulating air duct system: wind motor, centrifugal
- Bearing capacity of Thermal shock test chamber bottom plate: ≤40kg (uniform load)
- Thermal shock test chamber sample frame bearing capacity: ≤20Kg (uniform load)
- The total weight of the Thermal shock test chamber (bottom plate and sample rack) shall not exceed 50kg
- Single hinged door, hinged on the left side of the test chamber (facing the test chamber)
- Door size: 650×410 mm (WIDTH × height), door frame two silicone rubber sealing strip and anti-condensation electric heating device
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.