99.30% Accuracy SARS-CoV-2 Antigen Home Testing Kit 79*37*200MM

Rapid Antigen Test Kit SARS-CoV-2 Antigen Rapid Test Kit

Intend Use

This rapid test kit is intended for the qualitative detection of SARS-CoV-2 viral nucleocapsid antigens from human anterior nasal of secretion Testing result of the antigen test can be used for early isolation of patients with suspected infection, but it cannot be used as diagnosis basis of SARS-CoV-2 infection. Negative results do not rule out SARS-CoV-2 infection and should not be used as the sole basis for treatment.

Product Details

Test PRINCIPLE

This kit is an immunochromatography assay. According to the gold immunochromatographic test principle, double antibody sandwich method was used to detect SARS-CoV-2 nucleocapsid antigen in the samples. Whether the sample contains antigen or not, the gold monoclonal antibody will bind to the enveloped antibody at the quality control line, form a compound and condense into a red band.

Product  Feature

• Fast: Fast recation speed within 15 minutes
• Accurate: High Accuracy rate >90%
• Reliable: Individual Sample buffer, safety and reliability
• Simple: Simple operate step without extra step

 
Main Components

• Test Cassettes
• Sample tubes 
• Extraction Buffer
• Swabs
• Tube stand
• Instruction for use

 
Use Step

• Open the sealed pouch and remove the test casstette. Lay it face up on a clean, dry and flat surface.
• Unpack the sample extraction, add all of the sample extraction into the sample tube and then put the tube into tube stand.
• Gently, insert the entire absorbent tip of the swab (around 1.5 cm) into your nostril. Rotate walls of your nostril 5 times or more. Use the same swab to repeat steps in the other nostril.

• Insert the swab into the ssample tube with extraction buffer. Mix well. Mix well and squeeze the swab 10-15 times by compressing the walls of the tube against the swab. Roll the swab head against the inner wall of the tubes as you remove it.
• Close the cape of the sample tube. Add 3 full drops of the mixed solution vertically into the sample well(S) of the test cassette.
• Read the result 15-20minutes after adding the sample. Result got after 20 minutes is invalid.

 
Result Interpretation

• POSITIVE: Two colored bands appear on the membrane. One band appears in the control region (C) and another band appears in the test region (T).

• NEGATIVE: Only one colored band appears, in the control region (C). No apparent colored band appears in the test region (T).

• INVALID: If there is no Control line (C) or only a Test line (T) in the result window, the test did not run correctly and the results are not valid.

 

 
Virus Sources

 
Certificate