SS310 SS304 Packing Support Grid

                                                               Stainless Steel Packing Support Grid

The support grid is welded or bolted by a steel sheet to form a rigid support junction, which is the easiest and most widely used packing support plate. It is placed on the tower ring soldered on the wall or on the 4-8 support on the tower wall. These dimensions depend on the weight it bears. The cast iron grid is widely used in the chlorine industry, chlorine industry and sulfuric acid industry. The raster plate is widely used to support the regular filler. Sometimes it is also used to support random packing.

Structure and Size

The support grid is required to determine according to the following factors: tower, tower body elliptical, filler diameter, packing layer height, grid plate processing and installation and disassembly. The tower size is smaller, and the whole block is used. When the tower size is less than 350 mm, the grid can be welded directly on the wall, and the tower is 400-500 mm, and the grid is put on the support ring soldered in the wall. When the diameter is large, the block grid is applied. When the tower diameter is 600-800 mm, the grid plate is composed of two pieces. When the tower diameter is 900-1200mm, the grid plate consists of three pieces. When the tower is 1400-1600mm, the grid is constructed from four pieces. However, regardless of the grid plate into several pieces, it is necessary to put it on the support ring or support block soldered to the wall, and the support rings of the big tower are also enhanced. The block grid plate is 300-400 mm per block. The per weight cannot be too heavy for Install the disassembly into the manhole.

Picture