4G Hardwired Vehicle GPS Tracker
LT01 4G cat - 1 wired with gps platform for Car Motorcycle Truck Vehicle GPS Tracker
Main Features:
1. ACC Detection
Always keeps you informed of the ACC status of your vehicle.
2. Remote Cut-off
Immobilize a vehicle by cutting off its power source/fuel supply through an installed relay.
3. Speeding alarm
When the vehicle is over-speed, then it will be detected and send an alarm.
4. Geo-fence
A virtual area set on platform by yourself, you‘ll be informed when vehicle crossing its boundary.
5. Vibration Alarm
With built-in vibration sensor, an alarm will be sent immediately when the vehicle has abnormal vibration.
6. Power Off Alarm
Alerts when vehicle is powered off.
Parameters:
| Physical | Dimension | 88mm*45mm*14mm(L*W*H) |
| Weight | 47±5g | |
| Cellular | Lte module | Fibcom L610 |
| GPS |
Sensitivity: -147dBm Position accuracy:5-10m Accuracy: 5m CEP |
|
| Power | voltage | 9-100V |
| Battery | NI-MH 3.6V/60mA battery inside | |
| Power consumption |
Average Current: <30mA (DC 12V) Maximum current: <10mA (DC 12V) |
|
| Interface | Digital input(1) | Ignition |
| Digital output(1) | Relay | |
| GSM antenna | Inner | |
| GPS antenna | Inner | |
| Indicator | Green: GPS, Red: GSM | |
| Environmental Parameter | Working Temperature | -20℃ ~ +70℃ |
| Humidity | 5% ~ 95% (no fog) | |
| Ingress Protection Rating | IP65 | |
Alarm function
1. Low Voltage Alarm
When the battery voltage on the vehicle is too low (0-11V or 19-22V), device will report a low voltage alarm to the backend
2. Speeding, low speed alarm
When the vehicle speed is higher than the preset alarm value, the device will notify the backend. Similarly, when the vehicle speed is lower than preset alarm value, a low speed alarm will be uploaded to the backend, this value is configurable.
3. Vibration alarm
The device supports vibration alarm, 10 minutes after the ignition off (Arm range 1-20 minutes), the device generates vibration (Delay range 1-10 mins) without ACC connected, the device will upload vibration alarm.
4. Towing alarm
An alarm will be generated when the device is set to a displacement of more than 100 meters (message mode prompt), and the alarm information will be reported when the displacement radius exceeds 100 meters when the device is turned off. (Note: displacement range 100~2000m)
The device will send SMS if the vehicle is moved in ignition off status, if the radius is more than 100 meters, will upload towing alarm (Towing range:100-2000m)
5. GPS error alarm
When the device detects that the GPS/BD module is working abnormally, it reports the GPS receiver failure alarm to the backend
Parameter setting by SMS
The device is with unique ID number, the factory can preset t IP, port and APN for customers, generally there is no need for customers to do parameter setting; However in case any configuration needs to be done, please follow below instructions and make sure the SIMs has SMS functions available
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.