High Frequency Induction Heating Equipment Forging Heat Treatment Equipment For Small High-Frequency Quenching Machine

Overview of high-frequency induction heating products:

The high-frequency heater can be used to assemble or disassemble the inner sleeve, bearing inner ring, coupling, gear, etc. of cylindrical roller bearing, so that the efficiency of induction heating is higher. The ordinary power frequency heater has no way to disassemble small workpieces. At this time, the disassembler with medium cycle heating is used. The medium cycle induction heater has the advantages of high thermal efficiency, fast heating speed, etc.

Technical parameters of high frequency induction heating equipment:

Model: LC-GPGY-145KW

Maximum input current: 145A

Input power: 145kW

Oscillation frequency: 33khz

Input voltage: 380v

Host volume: 480mm×380mm×680mm

Cooling water pressure: 0.1-0.3mpa

Cooling water flow (main engine): 15L / min (0.1MPa)

Cooling water flow (transformer): 18L / min (0.1MPa)

Water temperature protection point: 50 ℃

Host weight: 40 ± 5% kg

Efficiency: 90%

Advantages of high-frequency induction heating equipment:

1. Fast heating, the fastest heating speed is less than 1s (the speed can be adjusted and controlled);

2. It is easy to install and connect the power supply, induction coil and water inlet and outlet pipes for use; Small size, light weight, easy to use;

3. Wide range of heating can be used to heat various metal workpieces (removable induction coils can be replaced according to different working switches);

4. When the power is controllable, the power can be adjusted to meet the needs of different heating temperatures and speeds

5. Less power consumption is about 70% less than that of the old electronic tube high-frequency equipment. The smaller the workpiece, the less power consumption;

6. The heating can be started after the quick opening water is powered on

7. It can be learned after a few minutes of simple operation;

8. The protection is fully equipped with alarm indications of overvoltage, overcurrent, overheating, water shortage, etc., and is automatically controlled and protected

9. Good effect, very uniform heating, fast temperature rise, less oxide layer, no waste after annealing;