Medical Health Malaria PfPv Antigen Rapid Test Kit

Description

Typical malaria is mostly cyclical, manifested as intermittent episodes of cold and heat. Usually, there are obvious chills, tremors, pale complexion, and cyanotic lips, chills last about 10 minutes to 2 hours, and then the body temperature rises rapidly, often reaching 40 ℃ or higher, flushing, dry and hot skin, irritability, After the high fever lasts for about 2 to 6 hours, the whole body sweats profusely, and the body temperature drops to normal or below normal after sweating profusely. After a period of intermission, the above-mentioned intermittent periodic chills and high fever episodes began to repeat. Infants and young children with malaria have an irregular fever, which can be manifested as persistent high fever or fluctuating body temperature. There may be no chills before the fever, or only symptoms such as cold limbs and pale complexion. Infants and young children with malaria are often prone to convulsions. The initial symptoms of malaria are similar to those of a cold, with intermittent fever, chills, and headache, and can lead to complications such as pulmonary edema, liver and kidney failure, anemia, and even coma. If not treated later, serious complications such as cerebral malaria, black fever urine, and even death may occur Plasmodium falciparum malaria can cause serious complications and affect the kidneys, liver, and brain blood.

Specification

rapid test kit.pdf

Picture details

CE Approved

All our rapid test kits have CE certifications that can be downloaded.

Test Procedure

①Please read the instructions carefully before testing.

② When stored at low temperature, the kit and collected experimental samples should be restored to room temperature before use.

③Aluminum foil bag is torn off. A test card is taken out and put flatly onto the surface of the operating table.

④Whole blood sample is drawn through a pipette separately at 5ul and then dripped into the sample injection hole of the test card. The cap of the bottle for the sample buffer solution enclosed in the kit is rotated off, and the bottle for the sample buffer solution is inverted. The sample buffer solution is dripped vertically by 3 drops (about 80 uL) into the sample injection hole. Then, the timing started.

⑤At 10~15 minutes, the final result is read. After 15 minutes, the test result must not be read. The results displayed after 30 minutes have no clinical significance.

⑥Note: The test had better be completed under room temperature (15~30℃).