Thin Stainless Steel Wire 304H 316L 0.13mm 3mm Cable Processing

1. Introduction

The safety factor K value of stainless steel wire in the drawing process is generally between 1.40 and 2.0, K< 1.40 indicates that the drawing stress σ1 is too large, and the wire after the die hole may continue to deform and appear the phenomenon of drawing or breaking, and the drawing process is unstable; K> 2.0 indicates that the drawing stress σ1 is small, the amount of drawing deformation is too small, and the drawing passes increase. When drawing the ultra-fine wire diameter is less than 0.05mm, it is difficult to pass the die. In order to improve the stability of the drawing process, reduce The Times of pulling and passing the die, and improve the production efficiency of drawing, the safety factor K value greater than 2.0 can be adopted.

2. Product Show