GB/T3880.1-2006 6082 Aluminium Strip Roll 0.1mm-6.5mm 0.1mm-6.5mm

The aluminum strip is an aluminum deep-processed product formed by slitting of aluminum coils. It is an important raw material in industry. The common series are 1000,3000,5000 and 8000 series.

Haomei can offer you anodised aluminium strip, common aluminum strip, thin aluminum strip and color coated aluminum strip.

Uses of Aluminum Strip Roll
It is mainly used in aluminum-plastic composite pipe, cable, optical cable ,transformer, heater, blinds, lamp base, caps, pharmaceutical caps,etc.

In plate form, 6082 is the alloy most commonly used for general machining. It is widely used in Europe and has replaced 6061 alloy in many applications, primarily due to its higher strength (from a large amount of manganese) and its excellent resistance to corrosion. It is typically seen in transport, scaffolding, bridges and general engineering.

Temper Types

F - As fabricated.
T5 - Cooled from an elevated temperature shaping process and artificially aged. Applies to products that are not cold worked after cooling.
T5511 - Cooled from an elevated temperature shaping process, stress relieved by stretching and artificially aged.
T6 - Solution heat treated and artificially aged.
O - Annealed. This is the lowest strength, highest ductility temper.
T4 - Solution heat treated and naturally aged to a substantially stable condition. Applies to products that are not cold worked after solution heat-treatment.
T6511 - Solution heat treated, stress relieved by stretching, and artificially aged.
Alloy 6082 Properties

Alloy 6082 offers similar, but not equivalent, physical characteristics to 6061 alloy, and slightly higher mechanical properties in the -T6 condition. It has good finishing characteristics and responds well to the most common anodic coatings (i.e., clear, clear and dye, hardcoat).

Various commercial joining methods (e.g., welding, brazing, etc.) can be applied to alloy 6082; however, heat treatment may reduce strength in the weld region. It provides good machinability in the –T5 and –T6 tempers, but chip breakers or special machining techniques (e.g., peck drilling) are recommended for improving chip formation.

The -0 or -T4 temper is recommended when bending or forming alloy 6082. It can also be difficult to produce thin walled extrusion shapes in 6082 alloy, so -T6 temper may not be available due to alloy quenching limitations.