Road sweeper

Chassis configuration: Dongfeng Tianjin original chassis, Cummins 180 engine, Dongfeng 6-speed gearbox, front axle 4.5t, rear axle 9t, 9.00R20 tires are used.

1. The garbage shall be collected by the way of suction and sweeping, and the road shall be cleaned by the way of wet dedusting, electro-hydraulic control and hydraulic tipping.

2. The auxiliary engine is used to drive the fan and hydraulic system to ensure the continuous operation and the continuity of the cleaning process.

3. The structure layout of "center four plate brush + rear suction nozzle plate" is adopted to facilitate the adjustment and maintenance of the cleaning device and suction nozzle, and the passing performance of the whole vehicle is good when transferring.

4. An automatic clutch is set between the auxiliary engine and the fan to ensure the automatic separation of the auxiliary engine from the fan during no-load start and stop, reduce the impact on the auxiliary engine, and improve the working reliability and service life of the auxiliary engine.

5. The scanning disk has the functions of automatic avoidance protection and automatic reset in case of obstacles. It retracts automatically when encountering obstacles, and resets automatically when crossing them.

6. According to different cleaning conditions, the rotating speed of the sweeper can be adjusted to ensure good cleaning effect under various pollution conditions.

7. It adopts advanced and efficient special fan and full floating suction nozzle which can automatically level with the road surface, with good cleaning effect and long service life.

project

parameter

Sub engine power 140 HP

Maximum total mass 16000kg

Maximum speed ≥ 95km / h

Sweeping width 3.3-3.5m

Water tank volume 3.5m3

Bin volume 7.2m3

Operation speed 5-20km / h

Maximum operation capacity 90000 m2 / h

Maximum suction 120mm

Cleaning efficiency ≥ 98%