Dry Sprayer Hydraulic Shotcrete Grouting Machine

Description of Dry Sprayer Shotcrete Grouting Machine

The machine is mainly driven by a motor, reducer, rotor assembly, sealing plate, rubber plate, compactor mechanism, hopper seat, mine wheel, vibration hopper, a compression mechanism, air Systems and electronic control devices, and other components. The motor shaft ends the drive gear shaft and, after decelerating by the gear unit, drives the rotor mounted on the output shaft to rotate.

Technical Parameter of Dry Sprayer Shotcrete Grouting Machine

Operational Requirements of  Dry Sprayer Shotcrete Grouting Machine

1. Before starting each shift, press the hand oil pump several times to fill the transmission parts with oil;

2. After the power is turned on, start the main motor first, and check whether the rotation direction of the rubber conveying screw is consistent with the direction indicated by the arrow. If it is inconsistent, replace the power phase wire. Note that this check must be performed every time the power is turned on again;

3. Connect the delivery hose and nozzle. Add 5 liters of clean water to the hopper, start the motor to pump out the clean water to wet the hopper, and pump the body and convey hose. After most of the clean water is pumped out, it can be stopped;

4. Add the proportioned mortar (or paint) into the hopper, start the air compressor and air valve, and then start spraying;

5. After the work is completed, the remaining material in the hopper should be drained immediately, and enough water should be injected into the hopper to thoroughly clean the hopper, and then the pump should be turned on to clean the hose and nozzle until the pump is full of clean water. , the cleaning is over. In order to prevent the residual material from condensing in the hopper, hose, and nozzle, blocking the hose and nozzle, and affecting the service life of the equipment.

maintenance Dry Sprayer Shotcrete Grouting Machine

1. Adjustment and homing: After the shotcrete works for a period of time, the rubber plate, steel lining plate, and other components will inevitably generate a kind of friction and form a gap. At this time, it needs to be manually adjusted to return it to its place.

2. Regularly check hydraulic components: hydraulic components refer to some components related to the pressure system, including fuel tanks, safety valves, etc. If there is a problem with these components, they should be dealt with immediately.

3. Add lubricating oil in time: For the concrete shotcrete machine, lubricating oil is essential. Without lubricating oil, it is difficult for the machine to run smoothly, and forced operation will damage the machine. In addition, if the lubricating oil is not clean enough, it will also cause wear and tear to the machine, so be sure to check whether the lubricating oil needs to be cleaned and added in daily maintenance.

4. In weather with low temperatures, after working every day, be sure to drain the water in the waterway system to prevent damage to the water pump or other components due to waterproof freezing.