ZXET ZX450 New Low Cost Cheap CDMA450MHz Mobile Phone External Antenna

DLNA Mobile Phone Battery Principle:

New batteries are partially charged at the factory. Before using your phone, you need to charge the battery according to the instructions below. Some batteries perform best after a few full charge-discharge cycles.
1. Connect the charging cable and the charging base. Insert the charger into the phone's connector port with the arrow pointing up.
2. Plug the other end of the charger into a suitable power outlet (100~240VAC).
3. When your phone indicates that the battery is fully charged, press the release tab and remove the travel charger.

DLNA Mobile Phone Battery Precautions:

1. Before charging, please make sure the battery is installed in the phone.
2. Even if the phone is turned off, the battery will gradually discharge. If the battery power is exhausted for a long time. Information stored in the phone may be lost. Therefore, even if you do not use your phone for a long time, you should charge the battery several times to avoid running out of power.
3. If the status light is blinking red, remove your travel charger and plug it back in. If this does not work, stop charging and have the charger repaired.
4. If the battery is extremely low. The main LCD may not light up even though charging has started. After charging for a period of time, the LCD can light up.

DLNA Mobile Phone Parameter:

DLNA Mobile Phone Function Building:

Media Format: required media formats and optional format configuration files;
Device Discovery Control and Media Management: Device Discovery and Control UPnP Device Architecture 1.0, Media Management and Control UPnP AV 1.0 and UPnP Printers: 1;
Media Transport: Media transport HTTP (mandatory) and RTP (optional);
Network stack: Network IPv4 suite;
Network Connections: Connect Ethernet, 802.11, and Bluetooth.