TWL6032A2B6YFFR High Efficient Power Path Management IC PMIC Fully Intg Low Noise 5.21 Mm × 5.36 Mm
TWL6032A2B6YFFR Power Path Management IC PMIC Fully Intg PWR Mgmt
1 Features
- Five Highly Efficient Buck Converters
- – One 3 MHz, 0.6 to 2.1 V at 5.0 A, DVS-Capable
- – One 6 MHz, 0.6 to 2.1 V at 2.5 A, DVS-Capable
- – Three6MHz,0.6to2.1Vat1.1A,OneIsDVS-
- Capable
- – Extended Mode for Higher Output Voltages
- 11 General-Purpose Low-Dropout Voltage Regulators (LDOs)
- – Six1.0to3.3Vat0.2AWithBatteryor
- Preregulated Supply:
- One Can be Used as Vibrator Driver
- One1.0to3.3Vat50mAWithBatteryor
- Preregulated Supply
- One Low-Noise 1.0 to 3.3 V at 50 mA With
- Battery or Preregulated Supply
- One3.3Vat100mAUSBLDO
- Two LDOs for TWL6032 Internal Use
2 Applications
-
Mobile Phones and Smart Phones
-
Tablets
-
Gaming Handsets
3 Description
The TWL6032 device is an integrated power-management integrated circuit (PMIC) for applications powered by a rechargeable battery. The device provides five configurable step-down converters with a current capability of up to 5.0 A for memory, processor core, I/O, auxiliary, preregulation for LDOs, and so forth. The device also contains nine LDO regulators for external use that can be supplied from a battery or a preregulated supply. The power-up and power-down controller is configurable and can support any power-up or power-down sequence (programmed in OTP memory). The RTC provides three 32-kHz clock outputs: seconds, minutes, hours, day, month, and year information; as well as alarm wakeup and timer. The TWL6032 device supports 32-kHz clock generation based on a crystal oscillator.
The device integrates a switched-mode system supply regulator from a USB connector. The switched- mode regulator includes power paths from the USB and battery with supplemental mode for immediate startup, even with an empty battery. The battery switch uses an external low-ohmic PMOS transistor allowing minimal serial resistance during fast charging and when operating from battery. The device can also be used without the external PMOS transistor; in this case, the battery is always tied to the system supply and the switched-mode regulator is used for battery charging.
The TWL6032 device is available in a 155-pin WCSP package, 5.21 mm × 5.36 mm with a 0.4-mm ball pitch.
Figure 1-1 shows the TWL6032 device block diagram.
Table Device Information
|
PART NUMBER |
PACKAGE |
BODY SIZE |
|
TWL6032A1Bx |
DSBGA15 |
5.21 mm × 5.36 mm |
|
TWL6032A2Bx |
DSBGA15 |
5.21 mm × 5.36 mm |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.