DURABLE Disposable Adult Blood Pressure Cuff Single tube NIBP cuff 27.5-36.5cm

OEM Part Number Cross References:

Patient:

Place the SpO2 sensor on the patient at the appropriate measurement site.

Application:

Before each use, clean the sensor and its cable.

Place the sensor on the index finger, ensuring that the finger is fully inserted and the tip of the finger rests against the finger stop inside the sensor.

Alternatively, you can use small-sized thumb, middle and ring fingers, as well as the little finger or the big toe as measurement sites.

Make sure the fingernail is located under the finger stop on the SpO2 sensor clamp.

Avoid placing the sensor on the same arm as the blood pressure cuff, arterial catheter, or intravascular line.

Remove all nail polish as it can affect accuracy.

Do not use the sensor inside or near an MRI.

Avoid having intense light sources near the sensor.

For long-term use, change the measurement site every 4 hours to maintain the integrity of the patient's skin.

In the case of restless patients or excessive motion, use Med Accessories Soft tip, wrap, or multi-site sensor to help secure the sensor to the patient.

Maintenance:

Regularly inspect the sensor and its cable for any signs of wear or damage. If any damage is detected, discontinue use and replace with a new sensor.

Clean the sensor and cable before each use according to the recommended cleaning instructions provided by Med Accessories.

Store the sensors in a clean and dry environment, following the storage guidelines provided by Med Accessories.

Follow any additional maintenance instructions provided by Med Accessories specific to the sensors you are using.

By following these installation, utilization, and maintenance guidelines, you can ensure the proper functioning, accuracy, and longevity of Med Accessories sensors, as well as the safety and comfort of the patients being monitored.