Metal Deburring Machine

General

To properly clean your belt disc edger and ensure its optimal operation and longevity, follow these guidelines:

Turn off the machine: Before starting the cleaning process, ensure that the disc edger is turned off and disconnected from the power source for safety.

Remove residue: Use a brush or air pressure device to gently remove any large particles of residue, such as metal shavings or dust, from the machine's surfaces and individual components. If necessary, utilize a vacuum cleaner or air pressure device to collect loose residue.

Cleaning fluid: Select a suitable cleaning fluid based on the material being processed, such as deionized water, detergent, or a specialized metal cleaner. Refer to the manufacturer's recommendations and instructions for the correct detergent and concentration to use.

Avoid damage: Take care to prevent cleaning fluid or water from directly entering the machine's interior or coming into contact with electrical components. Instead, dampen a cloth or use a sprayer to apply the cleaning liquid onto the cloth, and gently wipe the surfaces and parts of the machine.

Drying and lubrication: After cleaning, thoroughly dry the machine's surfaces and components using a clean cloth or paper towel. For parts that require lubrication, apply an appropriate lubricant as recommended by the manufacturer.

Safety guards and safety devices: Clean and inspect the machine's safety guards and safety devices to ensure they are free from dirt, damage, and properly installed.

​

SPECIFICATIONS

• Two large discs both at infeed side and outfeed side
• Large oscillation stroke over full width of the feed belt
• For deburring and edge rounding 3D punched parts
• For edge rounding and orbital finishing in one pass
• Working widths: 1000mm, 1500mm and 2000mm
• Smallest part size: 20mm x 20mm
• Material thickness: 0,3mm – 70mm (100mm)