wetting dispesant additive for UV Ceramic 3D Printing haze and viscosity reduction BYK111

ANJEKA6860 used for UV Ceramic 3D Printing

General Description:

Anjeka-6860 is a wetting and dispersing agent for solvent-based, solvent-free coatings, and printing inks. It stabilizes inorganic pigments, especially titanium dioxide, and significantly reduces the viscosity of grinding materials.

Product Data:

Chemical Composition: Copolymer solution containing acidic groups.

The data provided in this datasheet are typical values and are not product specifications.

Appearance: Colorless to pale yellow fluid

Acid Value (mg KOH/g): 50-150

Density (g/cm³ at 23℃): 1.00-1.30

Viscosity (cps at 25℃): 300-3000

Non-Volatile Content % (150℃, 20 min): ≥90

Storage and Transport:

Storage time should not exceed 12 months.

Special Notes:

The product should be stored in sealed containers and should not be stored again after pre-dilution.

Application Guidelines:

Coatings Industry:

Characteristics and Advantages:

Anjeka-6860 is mainly used for high solids and solvent-free coatings. Due to its anionic nature, it is very suitable for acid-catalyzed systems (e.g., coil coatings). Anjeka-6860 can stabilize inorganic pigments, especially titanium dioxide, increase gloss, reduce haze, and significantly reduce the viscosity of grinding materials.

Application Sectors:

Industrial Coatings: ●

Automotive Coatings: ●

Coil Coatings: ●

Anti-Corrosion Coating Systems: ●

●——Highly Recommended; ○——Recommended

Recommended Levels:

Additive amount (as received) based on pigment:

Inorganic Pigments: 2%-5%

Titanium Dioxide: 1%-3%

The above data are empirical amounts, and the optimal amount needs to be determined through a series of tests.

Incorporation and Processing Instructions:

For best performance, the additive should be added to the grinding material before adding the pigment.

Packaging:

25 kg iron drums

180 kg ring plastic drums