Gas Heat Treatment Furnace For Long Structural Parts Tempering / Normalizing / Annealing

Well Type Gas Heat Treatment Furnace Is Used For All Kinds Of Long Structural Parts Tempering, Normalizing, Annealing, Fire And Tempering Heat Treatment.

※ Product use:

Well type gas heat treatment furnace is used for heat treatment and tempering of various long structural parts. It is mainly used for heat treatment of large roller shaft products. It can be used for tempering, normalizing, annealing, fire and tempering heat treatment of products with weight not more than 10 tons and size not more than 900x6500mm.

※ Product Features:

1. The combustion medium is heated by natural gas, full combustion, no pollution, fast heating speed, the maximum use temperature can reach 650-1200℃, and the flue gas emission is in line with the "GB9078-88 industrial kiln smoke layer

Emission Standards;

2. The lining adopts alumina ceramic fiber module structure, the lining has small heat storage, low heat loss and significant energy saving;

3. High speed pulse burner is used for heating, and both sides are evenly distributed. Continuous proportional adjustment of combustion, the actuator to adjust the size of the air volume, through the proportional valve to adjust the size of the gas volume. Achieve air-fuel ratio combustion

The combustion, gas and air volume is provided with a lower limit, and the gas pipe of each burner is provided with a control solenoid valve. Each burner is equipped with an independent and complete combustion controller with automatic ignition and flame detection

Fire extinguishing alarm automatically cut off gas. This fully ensures the stability and safety of the combustion temperature control system:

4. Control system: intelligent PLC control type computer automatic control

※ Design and Manufacture certification:

1. The indicators are designed and manufactured according to the national standards of industrial furnaces

2. Conduct the performance test of various components and issue a report (support customer on-site pre-acceptance)

3. The export of equipment meets the international standards for export.

Technical parameter