100km~150km Range TDD Video Transmitter and Receiver Module with AES128 Encryption for UAV Datalink
- TDD OFDM video transmitter and receiver module for video data Link
- RF Power: 25±2dBm+10W external power amplifier
- Working Frequency: 806~826HMz, 1428~1468MHz, 2402~2482MHz
- Transparent IP Ethernet (2* Ethernet ports) and serial data(3* TTL/RS232 uart) sync telecommunication
- Audio input and output with codec
- Transmission range 100km~150km (UAV-to-ground) with 10W external power amplifier
- Great transfer rate for uplink and downlink
HCL5-M100 TDD video transmitter receiver module was designed for video data wireless transmission with two way wireless data link. This OFDM radio module works at 800MHz, 1.4GHz and 2.4GHz bands, with frequency hopping technology (FHSS) to ensure the stability of signal transmission.
| Name | 100km~150km TDD Video Transmitter and Receiver Module With Long Range UAV Datalink |
|---|---|
| Modulation | TDD OFDM |
| Model number | HCL5-M100 |
| Frequency | 806~826MHz, 1428~1468MHz, 2402~2482MHz |
| FHSS | Support |
| Bandwidths | 1.4/3/5/10/20MHz |
| Throughput | Maximum 30Mbps@20MHz |
| RF Transmission Power | 25±2 dBm+10W external power amplifier |
| Constellation | QPSK, 16QAM, 64QAM self adaption |
| Sensitivity | -106dBm (2.4GHz 1Mbps), -108dBm (1.4GHz 1Mbps), -108dBm (800MHz 1Mbps) |
| Ethernet ports | 2 * Ethernet ports for IP data transmission |
| Serial ports | 3 * RS232/3 * TTL for serial data transmission |
| Transmission Range | Up to 150km LOS (UAV-to-ground) |
| Management | Web UI and Control Uart |
| Encryption | AES128 |
| Networking Mode | Point to Point, Point to Multipoint, Relay, Mesh |
| Power Consumption | <40W |
| Modem Dimensions | 58*64*13mm |
| Modem Weight | 32g |
| Working Temp. | -20℃ ~ +65℃ |
| Storage Temp. | -40℃ ~ +80℃ |
| Power in | XT30PW-M connector, DC in: 7~30V |
|---|---|
| Ethernet 1 | 4Pin ZH1.5mm connector |
| Ethernet 2 | RJ45 connector |
| Data uart1 | 3PIN ZH1.5mm connector, TTL 3.3V |
| Data uart2 and uart3 | 6PIN PH1.25mm connector, uart3 works as control uart and data uart, TTL 3.3V |
| Audio input and output | 4PIN PH1.25mm connector |
| USB | Micro USB connector, for software upgrading |
| Switch | TX/RX control signal for outside power amplifier |
| Main-Antenna | TX/RX antenna port, IPEX |
| Second-Antenna | RX antenna port, IPEX |
| 12V out | On board 12V out (<150mA), for cool fan power supply |
| Power Led | Red, light on when normally powered |
| Node Led | Blue, light on when the module works as central node |
| Link Led | Light off - node not linked; Red - linked with weak signal; Orange - linked with medium signal; Green - linked with strong signal |

The TDD video transmitter receiver module supports two operating modes: Access Node or Central Node. It can be managed through Web UI or AT command via uart3. The module supports up to 16 Access Nodes connected to a Central Node, all sharing the maximum 30Mbps@20MHz throughput bandwidth. Uplink and downlink stream ratio can be controlled through web UI or AT command.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.