Wireless TDD COFDM Full Duplex RF Transceiver Data Network IP Radio For Drone
- TDD OFDM full duplex IP Video Data transceiver ideal for drone application.
- Point to point and point to multipoint networks are supported
- Can be controlled via web browser or through serial port
- 3 Ethernet for audio video transmission and 1 channel RS232/TTL for bidirectional data link
- 300mW*2 RF dual power supply for wireless video data transmission
- Used in pairs - transmitter on drone and receiver on ground (same hardware, different settings)
Hincn HCL601 duplex IP video data transceiver operates in the 600MHz or 1.4GHz bands with two way wireless data link. It combines with FHSS(Frequency-Hopping Spread Spectrum) and TDD OFDM technology to make sure better stability signal communication even in rapid movement condition.
| Model number | HCL601 |
|---|---|
| Modulation | TDD OFDM |
| Frequency | 566~678MHz and 1420~1530MHz |
| Bandwidths | 3/5/10/20/40MHz |
| Throughput | Maximum 100Mbps |
| RF transmission Power | 300mW *2 (Each 300mW of the 2 antennas) |
| Constellation | QPSK,16QAM,64QAM, self-adaption |
| Sensitivity | -102dBm (1Mbps at 20MHz) |
| IP data transmission | 3 Ethernet ports |
| Serial data transmission | 1 channel RS232 or TTL |
| Transmission range | 1~2km (ground to ground), 5~22km (drone to ground) |
| Management | Through Web UI or Control UART |
| Encryption | AES128-bit encryption |
| Network mode | Point-to-Point, Point-to-Multipoint, Relay, and Mesh (specify) |
| Movement speed | Support maximum 120km/h |
| Power input | 7~18V |
| Power consumption | <8W |
| Dimensions | 83.7*61.4*19 mm |
| Weight | 98g |
| Connection | Description |
|---|---|
| Ethernet | 3 channel 4Pin PH1.25mm connector, bridged inside with same IP address |
| Data UART | RS232 data UART, 3PIN PH1.25mm connector |
| Control UART | TTL control UART, 3PIN PH1.25mm connector |
| Power in | XT30PW-M connector |
| ANT 1 | Tx/Rx Antenna port, SMA female |
| ANT 2 | Tx/Rx Antenna port, SMA female |
Application:
HCL601 duplex IP video data transceiver is a new type of full duplx communication radio used in mobile communication systems, uses two separate channels for uplink and downlink transmission. It is a lightweight TDD OFDM modulation Network IP radios with 300mW*2 rf power output. Due to its lightweight and mini size, it meets the requirements of various drone and robots for video data transmission via IP camcorder or computer connection.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.