XBSY Oil-Based Mud Treatment System: <8% Oil on Cuttings & Skid-Mounted Design

The XBSY Oil-Based Mud Treatment System integrates a cutting dryer, centrifuge, screw conveyor, collection tank, shale shaker, and fluid recovery equipment. Drilling waste undergoes sequential drying and separation: solids are dehydrated to minimize water content, while recovered oil-based mud (OBM) is returned to the circulation system. This closed-loop process reduces incineration energy consumption by 40% and eliminates onsite waste accumulation. The skid-mounted design enables rapid deployment in remote rig sites.
Post-treatment drill cuttings achieve oil content below 8%, meeting international disposal standards for safe bagging and transportation. The liquid phase density drops to 1.2g/cm³ (versus industry-average 1.35g/cm³), allowing direct reinjection into active mud systems. This recovery slashes new mud procurement costs by 30% and cuts hazardous waste volumes by 70%, aligning with zero-discharge environmental policies.

Features
Skid-mounted Unit - Convenient for lifting, transportation, and on-site placement.
Low Oil Content - The oil content of the treated drill cuttings is less than 8%, which is convenient for bagging and transportation.
Lower the Density of Liquid Phase - The density of the treated liquid phase can be reduced to 1.2g/cm³, much lower than the 1.35g/cm³ of ordinary oil-based drill cuttings treatment equipment, and can be directly returned to the mud circulation system for reuse.